top of page
226_preparat-czyszczcy-do-pistoletw-z-do

GREINPLAST ACS

Cleaning preparation with silicone, to be used in guns

Used to remove unhardened foams and polyurethane glues, to clean valves in application containers and guns.  Thanks to a new formula, the cleaned surfaces are also lubricated and preserved. The preparation leaves an anti-adhesive layer on surfaces, which largely extends the lifetime of used tools, which is especially important in guns and applicators dispensing polyurethane substances.

Packaged in 500 ml containers.

​

PREPARATION

Apply the attached spraying head onto the valve. Spray onto fresh stain of foams or polyurethane glues. When cleaning a stained outlet in a polyurethane foam container, carefully spray the preparation onto the valve and gun adaptor. Remove stains with a dry cloth. When cleaning the gun, detach it from the polyurethane foam container, and remove the remaining foam by pressing the gun trigger. Next, spray Greinplast ACS onto the gun socket. Remove the spraying head and place the preparation in the gun socket, then press the gun trigger again. Repeat until the gun is completely clean.

​

​

Downloads

Recommendations and remarks

Application temperature between +5°C and +30°C. Before use, make yourself familiar with warnings and OHS recommendations. Do not use the preparation in enclosed spaces and at temperatures exceeding +35°C Do not mix with other chemical substances. Do not leave Greinplast ACS attached to the gun, as this may cause damage to its sealing. Do not disassemble the gun to clean it.
Information contained in the manual help ensure the optimal use of the product, however, it does not create any legal liability of the Manufacturer, due to the fact that the conditions of use remain outside of its control.

bottom of page