top of page
163_preparat-do-usuwania-zabrudze-minera

Downloads

GREINPLAST AM

Preparation removing mineral stains

Used to remove remains of cement, construction mortars, glaze glues, rusty runs, mineral residues from concrete, ceramic and steel surfaces.  It is also very effective in the removal of lime efflerescences and deposits. When removing stains, follow guidelines printed on the preparation package. When used properly, the product does not damage rubber, glass, painted, ceramic and metal surfaces (except for non-ferrous metals, galvanised and nickel-plated).

Packaged in 5, and 1l containers.

​

PREPARATION

Dilute the concentration in cold water. To remove concrete stains, it is recommended that the substance should be used at a proportion of 1:5; with heavy contamination, use the concentration itself. To clean rusty layers, mineral deposits etc. use the concentration at a proportion of 1:1-1:20. Before the substance is applied, slightly moisturise the cleaned surface with water. Using a brush or a low-pressure spraying device, apply the preparation onto the soiled surface (do not use the so-called mist), wait for 5-10 minutes and rinse with plenty of water. Do not allow the preparation to dry on the cleaned surface. In case no visible effects are achieved, repeat the procedure.

Recommendations and remarks

The temperature of the base and its surroundings during the application should not be lower than +5°C. The preparation contains substances hazardous to human health (hydrochloric acid). During the preparation application, use personal protection equipment (protective clothing, gloves and safety goggles). Secure all surface that do not require cleaning. Caustic – avoid contact with the skin and eyes. Before the preparation is used on the entire cleaned surface, make a test at a concealed spot. The preparation must be used in accordance with the manual; failure to do so may result in damages on the cleaned surface.

bottom of page