top of page



Bitumen insulation and gluing mass, solvent-based

Used to glue EPS and XPS panels, laminated panels (EPS/roofing membrane), mineral wool, wood derivatives and other thermal insulation materials used in floors and roofing. The mortar can also be used as hydro-insulation in underground segments of buildings and edifices (continuous footing, foundations etc.).

ATTENTION!!! Use outdoors, in well-ventilated locations. Do not use with tar boards, tar boards with aluminium tapes and to glue tar board with EPS.

Packaged in 20, 10 & 5kg containers.


GLUING EPS PANELS: Apply the mass in spots (10-12 spots per a 0.5 m2 panel), or with a toothed trowel. Once glue is applied, press the panel against the base. Gluing should begin from the excavation bottom.
HOW TO MAKE HYDRO-INSULATION: The mass should be applied with a metal trowel at a thickness 1-1.5 mm, minimum in two layers (subsequent layers should be applied when the previous one is dry, in perpendicular against the previous one). Make plaster coves in corners. If it is necessary to use the mass in low temperatures, put the product in a warm room 24 hours before the commencement of works.

Recommendations and remarks

The temperature of the base and its surroundings during the application and drying should be between +5°C and +35°C. The optimal application temperature is +20°C. The specified processing times may vary under the influence of adverse thermal and moisture conditions. Areas exposed to soiling should be secured. Any stains should be removed before they dry up. Dry stains should be removed with organic solvents.

bottom of page