top of page
131_zaprawa-tynkarska-lekka_151020020523

GREINPLAST ZTL

Light plaster mortar

Used to lay cement-lime plasters with the use of machines (plastering units) on I-III surface categories, inside buildings. The product is classified as light plaster mortar (LW type), with compression strength of CS II category (1.5-5.0 N/mm2) and W0 water absorption category. It can be used after the previous placement of a priming layer (so-called rough coat), made with Greinplast ZTP mortar.

Packaged in 30kg containers.

​

PREPARATION

The temperature of the base and its surroundings during the mortar application and drying should be between +5°C and +30°C. The plaster-covered surfaces should be protected against drying too fast and moisture. Tools should be washed with water directly after the completion of works.
Information contained in the manual help ensure the optimal use of the product, however, it does not create any legal liability of the Manufacturer, due to the fact that the conditions of use remain outside of its control. We do not accept any responsibility if the material is combined with products from other Manufacturers.

Properties

ztl.PNG

Downloads

Recommendations and remarks

The temperature of the base and its surroundings during the application and drying should be between +5°C and +30°C. The specified processing times may vary under the influence of adverse thermal and moisture conditions. Areas exposed to soiling should be secured.
Information contained on the package help ensure the optimal use of the product, however, it does not create any legal liability of the Manufacturer, due to the fact that the conditions of use remain outside of its control. In order to avoid mistakes, check the suitability of the substance for the intended application, or ask the manufacturer for technical advice. Any attempts to change the composition of the product are not allowed, as they may considerably reduce its quality. We do not accept any responsibility if the material is combined with products from other Manufacturers.
 

bottom of page